Re: Converting from an ancient BASIC to new database

On Sat, 23 Jun 2007 23:28:06 -0700, James <JT@[EMAIL PROTECTED]
> wrote:

>ArarghMail706NOSPAM@[EMAIL PROTECTED]
 wrote:
>> On Fri, 22 Jun 2007 13:34:49 -0700, James <JT@[EMAIL PROTECTED]
> wrote:
>> 
>> <snip>
>>> A later post suggests using a standard basic to run your system & I 
>>> agree, to a point.  If your program used any of the machine specific 
>>> calls, embedded assembly language, etc. it may not be as easy as it 
>>> first appears.  I had a "basic" language database in the early 80's
that 
>>> handled over 20,000 customers & over 20,000 items with bar code for
UPC 
>> 
>> Just out of curiosity, which one?
>> 
>> <snip>
>At that time it was setup to run on the Trs80 Mdl III/IV using M$Basic, 
>& some assembly code for the bar code reader.
>
Ok, thanks.
-- 
ArarghMail706 at [drop the 'http://www.'
from ->] http://www.arargh.com
BCET Basic Compiler Page: http://www.arargh.com/basic/index.html

To reply by email, remove the extra stuff from the reply address.